Passive EM Sweep Locating in Burnaby, BC

EM line tracing is largely soil-independent — it follows the signal on the conductor regardless of what's around it — but GPR, the half that finds non-conductive plastic and clay lines, is very soil-sensitive. Burnaby sits on predominantly glacial till slopes with peat pockets around Burnaby Lake and Big Bend. Till slopes give clean 2–3 m penetration; peat and high water table near Burnaby Lake and Big Bend cut effective depth — survey design accounts for it. So in Burnaby we lean on EM for the metal and tracer-wired lines and set realistic GPR expectations for the plastic — which is exactly why running both methods matters here.

The local mix follows the building stock: Metrotown and Brentwood tower clusters on post-tensioned slabs, 1960s–70s walk-ups mid-slope, and heavy industrial along the Fraser. Underneath that, the everyday Burnaby locate is private water and irrigation services, power to outbuildings and gates, gas to outdoor features, and the plastic mains that need GPR or sonde tracing — the private-side utilities no public locate covers.

Yes. BC One Call marks member utilities' public lines to the property line across Burnaby and all of BC — it does not locate the private services beyond it, which is where most strikes happen. The EM + GPR clearance survey covers those private lines. Use both: BC One Call for the public locates, a private dual-method locate for everything on your side.

Province-wide pricing — no regional premium for Burnaby or anywhere in the Metro Vancouver. A focused clearance (a dig area, a fence line) starts in the low-to-mid hundreds; full-site mapping and SUE-grade work are quoted by scope. The free phone consult (604-239-9934) gives a firm number in about five minutes. Mon–Sat, 8am–6pm PT.

Because its job is safety-first discovery, not identification. The power-mode sweep flags energised cables — the highest-consequence strike risk — before anyone applies a signal or breaks ground, and the radio sweep catches conductive lines you didn't know were there. It's the fast opening pass that tells the active-locating and GPR work where to concentrate.

No — passive detection needs the line to carry or re-radiate a signal, and bare plastic carries nothing. Plastic water mains, PVC/clay sewer, and similar non-conductive utilities are invisible to every EM mode; they're found by GPR imaging or by tracing a tracer wire or sonde. A passive 'all clear' is never a real all-clear on its own, which is exactly why we never stop there.